HORIZONTAL STRUCTURE 1 SOLAR PANEL 30º 20H

Horizontal Structure 1 Solar Panel 30º 20H

Technical Description Flat Horizontal Structure/Floor 1 Panel 30º

The horizontal flat structure/floor panel 1 30º is designed to support solar panels aligned horizontally on a flat surface that does not have the appropriate tilt or orientation. This structure model is suitable for any type of solar panel with a width greater than 1 meter and a maximum length of approximately 2.1 meters. It is suitable for any type of panel that does not exceed these measurements. Its legs are pre-assembled closed triangles to guarantee superior solidity. The rear reinforcements are responsible for providing greater rigidity to the whole. The support surface is very long so that

The Horizontal Flat Structure/Floor 1 Panel 30º is designed to be installed in the orientation that interests us and always arranging the panels horizontally. The row of panels will have a standard inclination of 30º with respect to the surface on which the structure is anchored. As an option, 15º can be requested, in case it is installed on a slightly inclined surface, but not enough.

You will receive your Flat/Floor Horizontal Structure 1 Panel 30º with a detailed assembly diagram so that you can install the structure easily and without complications.

The 1 panel 30º horizontal flat/ground structure is designed for use with all types of solar modules, as long as they do not exceed 2.1 x 1.05 meters. Its clamps admit different types of profile thickness, between 33 and 50 mm.

The anchoring screws for the Flat Horizontal Structure Panel/Floor 1 30º to the surface where it is going to be installed are not included. Depending on the surface where it is placed (concrete, metal roofing, etc.), you will need one type of screw or another that you will have to purchase yourself. Keep in mind that the surface where it is installed is capable of supporting, in addition to the weight, the stresses caused by the wind. It is your responsibility to ensure that it is installed in a safe and solid place. The advantage of the Horizontal Flat/Floor 1 Panel 30º Structure is the speed with which the structure can be installed, as the triangles are pre-assembled and no special tools are required other than an adjustable spanner or spanner. tube and all that is needed.

The materials of the horizontal flat structure/floor 1 panel 30º are completely made of high quality aluminum, while the screws and accessories are made of stainless steel.

The EN AW 6005A T6 alloy is a high strength aluminum alloy, for this reason, as well as for its ability to be anodized, it is used to manufacture structural profiles. All the structures present can be offered in anodized aluminum, whose advantage over raw aluminum structures is the greater resistance to corrosion.

The packaging of the Horizontal Flat Structure/Floor 1 Panel 30º is unitary, so if, for example, you need a structure for 4 panels, you must buy 4 units of this model.

Horizontal Flat Structure/Floor 1 Panel 30º

Technical Data Sheet View Flat Horizontal Structure/Floor 1 Panel 30º Technical Data Sheet