STRUCTURE PANEL COPLANAR FALCAT

Falcat Solar Panel Structure choose the number of solar panels from the drop-down menu

Description Structure 1 Coplanar Panel Falcat

The structure is designed to be installed in a vertical position, with the same inclination as the existing roof. Horizontal installation is also possible, holding its panels on the wider side.

This type of structure is designed to withstand snow loads of up to 50 cm and a wind speed of about 45 m/s. For there to be no problem, before laying the fixing of the sheet must be checked and that it is capable of supporting these loads. These checks are very interesting when the sheet is sandwiched, due to its normally low support capacity. The recommended minimum thickness of the trapezoidal sheet is, as a rule, 0.6 mm.

Structural materials 1 Falcat coplanar panel

The materials of the structure are 6005 T5 anodized aluminum and stainless steel. Anodized aluminum 6005 T5 is a very strong aluminum alloy due to its ability to be anodized and is used to manufacture structural profiles. All the structures present can be offered in anodized aluminum, whose advantage over raw aluminum structures is the greater resistance to corrosion.

Falcat Coplanar Structure 1 Panel Data Sheet and Manual

View the Falcat Structure 1 Coplanar Panel Data Sheet

See the Falcat Coplanar Structure 1 Panel manual